A carbon–LiFePO<Subscript>4</Subscript> nanocomposite as high-performance cathode material for lithium-ion batteries

A cathode material of an electrically conducting carbon–LiFePO₄ nanocomposite is synthesized by wet ball milling and spray drying of precursor powders prior to a solid-state reaction. The structural characterization shows that the composite is composed of LiFePO₄ crystals and 4.8 wt.% amorphous carbon. Galvanostatic charge/discharge measurements indicate that the composite exhibits a superior high energy and high cycling stability. This composite delivers a discharge capacity of 159.1 mAh g⁻¹ at 0.1 C, 150.8 mAh g⁻¹ at 1 C, and 140.1 mAh g⁻¹ at 2 C rate. The capacity retention of 99% is achieved after 200 cycles at 2 C. The 18,650 cylindrical batteries are assembled using the composite as cathode materials and demonstrate the capacity of 1,400 mAh and the capacity retention of 97% after 100 cycles at 1 C. These results reveal that the as-prepared LiFePO₄–carbon composite is one of the promising cathode materials for high-performance, advanced lithium-ion batteries directed to the hybrid electric vehicle and pure electric vehicle markets.     

Infrared spectra study of Nd1.85−xRxCe0.15CuO4±δ (R = Gd and Sm) single crystals

The X-ray diffraction (XRD), Fourier transform infrared (FTIR) spectra, and resistivity ρ are measured on Nd_1.85?xR_xCe_0.15CuO_4±δ (R = Gd and Sm) single crystals. From the XRD and FTIR spectra studies, the lattice constant c are found to decrease faster for Gd doping than that for Sm doping with increasing doping concentration x. Upon Gd doping, all the transmission peaks shift to high frequency but nearly unchanged with increasing Sm doping content. The volume of the unit cell observed through XRD and FTIR spectra decreases faster for Gd doping than that for Sm doping. Furthermore, for Gd doping the superconducting T_c decreases rapidly with increasing the doping concentration, while the T_c decreases slowly for Sm doping with increasing Sm content, which is found to be very well consistent with the evolution of the volume of the unit cell for two series.     

Fluorescence switch of dye-infiltrated SiO<Subscript>2</Subscript> inverse opal based on acid-base vapors or light

The acid-base vapors/light double responsive dye-infiltrated SiO₂ inverse opal photonic crystals (PCs) were fabricated by sacrificial template method and a subsequent infiltration of spiropyran derivative dye molecules. The fluorescence of ring-open dye molecules infiltrated in PCs can be switched on/off based on different fluorescence properties of spiropyran dye under stimuli of acid-base vapors or light, when PCs with suitable stopband were selected. The fluorescence switch behavior based on PCs has potential applications in data storage, color displays, chemical and biological sensors.     

Low-frequency and broad band metamaterial absorber: design, fabrication, and characterization

We report a metamaterial absorber (MA) with a broad absorption band in the frequency region of 2–4 GHz, whose thickness is not limited to the quarter-wavelength. Theoretical and experimental results show that the absorber has two adjacent absorption apexes at 2.24 and 3.46 GHz, respectively, which are both related to the electric and magnetic resonances of the metamaterial. The absorption is over 68% in the whole wave band of 2–4 GHz provided the thickness of 4 mm. The distributions of the surface currents and the power loss density indicate that the surface currents produced by the electric and magnetic resonances are strongly consumed by the resistive patches. This low-frequency absorber has potential applications in many scientific and martial fields.     

纳米TiO2叶片状阵列电极的制备及其在染料敏化太阳电池中电子的输运性能

在低温条件下采用定向刻蚀技术, 对金属Ti片表面用H₂O₂溶液进行刻蚀氧化, 制备了垂直生长的纳米TiO₂叶片状阵列薄膜电极. 通过X射线衍射分析表明, 纳米TiO₂叶片状阵列薄膜经500 ℃下烧结1 h后, 从无定型转变为锐钛矿相. 场发射扫描电子显微镜观察表明: 在80 ℃下的H₂O₂溶液刻蚀氧化, 经1 d制备得到的是Ti片表面垂直生长的叶片状阵列, 其形貌均匀且完整地 关键词： 2')" href="#">纳米TiO₂ 叶片状阵列电极 染料敏化太阳电池 电子传输     

负偏压作用下染料敏化太阳电池界面及光电性能研究

太阳电池组件由于局部电压不匹配,其中部分电池可能较长时间工作在负偏压状态下,从而影响电池光电性能.借助拉曼光谱、电化学阻抗谱和入射单色光量子效率(IPCE)等测试手段,研究长期负偏压作用下染料敏化太阳电池光电性能的变化及其影响机理.拉曼光谱研究结果表明:电池在1000 h负偏压作用下,电解质中阳离子(Li⁺)会向光阳极(TiO₂电极)移动并嵌入TiO₂薄膜中;长期负偏压作用还会致使TiO₂/电解质界面阻抗增大和IPCE下降,导致电池开路电压升高和短路电流减小.通过加入苯并咪唑(BI)添加剂,经1000 h负偏压后电池的拉曼光谱实验表明,BI能在一定程度阻碍Li⁺的嵌入,电池具有较好的长期稳定性.不同负偏压下的老化实验进一步表明,通过加入添加剂能够使电池在长期负偏压下保持较好的稳定性. 关键词： 染料敏化 太阳电池 组件 负偏压     

固相反应法制备的Gd0.7Sr0.3MnO3粉末的磁学特性

利用固相反应法制备了用Sr部分替换GdMnO3中Gd的锰基钙钛矿氧化物Gd0.7Sr0.3MnO3.X射线衍射表明其晶体结构为正交晶系,空间群为Pnma.通过测量样品在零场冷却和加场冷却下的磁化强度及磁化率随温度的变化曲线,得出样品显示亚铁磁特性,Mn和Gd两个子晶格相互反平行.根据居里-外斯定律得知其居里温度为61 ...     

The electric field modulation by three-dimensional crack on fused silica subsurface

The main factor of laser-induced damage is the modulation to electromagnetic field of laser by the crack on the subsurface. In this paper, a three-dimensional crack model on the exit surface is presented. Three-dimensional finite-difference time-domain (FDTD) method is employed to simulate the electric field intensity distribution in the vicinity of crack on fused silica subsurface. The roles of the crack width, depth, length and the gradient angle in the modulation to the incident light field are analyzed in detail. Results show that the crack size plays an important role in the electric modulation. With the increasing depth and width, the peak value of maximal electric field intensity appears in fused silica. However, the maximal electric field intensity tends to be a constant when the crack length reaches 1 μm. Besides, the enhancement of light intensity becomes obvious when total internal reflection occurs in fused silica. Our calculated results provide an advisable theoretical criterion to the corresponding experiment.     

Photonic generation of microwave signals using dual-wavelength single-longitudinal-mode fiber lasers

Photonic generation of microwave signals is demonstrated with a dual-wavelength single-longitudinal-mode erbium-doped fiber ring laser. Microwave signal with a frequency of 21.07 GHz is obtained by aligning the reflection band of a uniform fiber Bragg grating to the two transmission peaks within a fiber Bragg grating-based Fabry-Perot filter. Stable dual-wavelength single-longitudinal-mode operation is guaranteed by means of the combined filtering effect of a saturable absorber and the Fabry-Perot filter. This approach provides an effective solution to the photonic generation of high-frequency microwave signals.     

Directional coupler design based on coupled cavity waveguides in photonic crystals

We propose a directional coupler design based on coupled cavity waveguide in photonic crystals. The plane wave expansion is used to give the dispersion of the coupled cavity waveguides and two parallel such waveguides. The couple length is got from the dispersion curves. Based on the research of the dispersion, we present a directional coupler and the transmission property is given. This structure is potentially important for highly efficient directional coupler in integrate optical circuit.